Read More
Read More
I spy 2 sets of forks! details?
No, you spy 2 forks, or one (mismatched) set of forks! I switched from my stock LTD fork to a GPz fork a couple years back. The LTD is longer and has an offset axle, and the GPz fork features an air pressure balance tube and stiffer springs (they're progressive, but I don't think they're Progressive).
you already cleaned up the ports on that head and did a valve job a while back, right?
Define "valve job"... These are the stock valves, guides, & seats. I didn't do a proper grind on them or anything, just chucked the valves up in the drill press and cleaned off the build up. I guess it's a poor man's valve job...
I made the mature decision to go back with my stock cams instead of the GPz cams. I've already sacrificed my low end torque for the sake of more horsepower, I don't want to give this thing a "light switch" power band. The GPz cams apparently concentrate all the power into a zone just below redline. If I was building a track bike, there'd be no question about it, I'd use the lumpy cams! Besides, I'd have to get a whole different set of valve shims and get this electric tach working if I want to use them. I'll hang onto them, in case I change my mind... which I'm sure I'll do at some point...
It's drag race Friday again this week! Taking the mustang this time.
About got 'er dialed in, eh?
I forget, have you taken your ZRX to the drag races? I'm thinking that'd be your quickest vehicle...
Read More
Read More
Years ago, I was on the road with this country band. The steel guitar player was this crusty old fucker who'd seen everything. I told him about this Mother Trucker / The Mother Truckers thing, and he said, "Oh yeah, I was in Jizz Mopper. No, not The Jizz Moppers, though we did get to open for them once..."
Situational awareness is the key to a better life.
Read More
Looking to sell the truck anyway, i got to get something that doesn't eat 8 gallons of gas upon startup
Read More
Read More

How hard is it to remove those pipe inserts? Would you need to rejet or mess with your needle height? Do those carbs even have jet needles?
Once you get the hang of this, I can see you taking the ZRX to the strip...
Oh, and try to get somebody to shoot some photos or a little video clip of your launch if you can!
The real shame is he fucked somebody else up.